BMW C400GT - Rider's Manual > Calibrating ASC
Requirement
Lower stability reserves of the ASC control after a tire change.
NOTICE Calibration means that the control is adapted to the effective tire radii of the front and rear wheels.
The effective tire radii depend on the tire brand, tread depth, tire pressure and payload.
Every time the tires are changed, calibrate the ASC control to adapt it to the new tire radii.
As tire wear progresses, calibrate the ASC control regularly to keep it functioning optimally.
- Before calibration, the ignition must have been switched off for at least 1 minute.
- Switch on ASC.
SETUP ASC ON is displayed.
- Press and hold the bottom of the MENU rocker button 2 to start
calibration.
CAL 3 flashes.
ASC indicator and warning light
begins to light up.
Rocker buttons MENU 1 and 2 have no function.
The menu item can only be exited if the ignition is switched off and on again.
The calibration has been started and waits for the Scooter to be operated.
ATTENTION ASC is not available until calibration is completed
Accident hazard
- Carry out calibration on a flat and straight stretch of road that has good adhesion.
- Ride straight ahead and remain in the following speed range for 6 seconds, keeping your speed as constant as possible.
- ASC is calibrated.
ASC indicator and warning light
goes out.
ODO is displayed.
ASC calibration has been completed.
The trip can be resumed.
Calibrating ASC
- with Connectivity OE
Requirement
- Lower stability reserves of the ASC control after a tire change.
NOTICE Calibration means that the control is adapted to the effective tire radii of the front and rear wheels.
The effective tire radii depend on the tire brand, tread depth, tire pressure and payload.
Every time the tires are changed, calibrate the ASC control to adapt it to the new tire radii.
As tire wear progresses, calibrate the ASC control regularly to keep it functioning optimally.
- Before calibration, the ignition must have been switched off for at least 1 minute.
- with Connectivity OE
- Switch on ASC.
ASC is activated.
- Call up Start ASC calibration and start the calibration.
The calibration has been started and waits for the Scooter to be operated.
ASC indicator and warning light
begins to light up.
The menu item can only be exited if the ignition is switched off and on again.
ATTENTION ASC is not available until calibration is completed
Accident hazard
- Carry out calibration on a flat and straight stretch of road that has good adhesion.
- Ride straight ahead and remain in the following speed range for 6 seconds, keeping your speed as constant as possible.
- ASC is calibrated.
ASC indicator and warning light
goes out.
ASC calibration has been completed.
The trip can be resumed.
See also:
BMW C400GT - Rider's Manual > Deactivating ASC
Requirement The Scooter is stationary. Switch on the ignition. Selecting SETUP. SETUP ASC is displayed. Briefly press the bottom of the MENU rocker button to change between ASC ON 1 and ASC OFF.
BMW C400GT - Rider's Manual > Time and date
Set clock Requirement The Scooter is stationary. Switch on the ignition. Selecting SETUP. SETUP CLOCK is displayed. Press and hold the bottom of the MENU rocker button to set the hours.
