Kymco XCITING 500 - Service Manual > Brake Light Switch

Lights/Meters/Switches / Brake Light Switch

Remove the upper handlebar cover.

Disconnect front or rear light switch connector and check for continuity between the switch terminals.

There should be continuity with the front or rear brake lever squeezed, and there should be no continuity with the front or rear brake lever is released.

Lights/Meters/Switches

IGNITION SWITCH

INSPECTION

Remove the front cover.

Disconnect the ignition switch connector and check for continuity at the switch side connector terminals.

Continuity should exist between the color code wires as follows:

Lights/Meters/Switches

Lights/Meters/Switches

HANDLEBAR SWITCH

INSPECTION

Remove the front cover.

Right handlebar switch

Disconnect the right handlebar switch connector and check for continuity at switch side connector terminals.

Continuity should exist between the color code wires as follows:

Lights/Meters/Switches

Lights/Meters/Switches

Lights/Meters/Switches

Lights/Meters/Switches

Lights/Meters/Switches

Left handlebar switch

Disconnect the left handlebar switch connector and check for continuity at switch side connector terminals.

Continuity should exist between the color code wires as follows:

Lights/Meters/Switches

Lights/Meters/Switches

Lights/Meters/Switches

Lights/Meters/Switches

Lights/Meters/Switches

Lights/Meters/Switches

PARKING SWITCH

INSPECTION

Remove the front cover.

Disconnect the parking switch connector and check for continuity between the switch terminals.

There should be continuity with the parking lever pull up, and there should be no continuity with the front brake lever is push down.

Lights/Meters/Switches

LUGGAGE BOX LIGHT SWITCH

INSPECTION

Remove the luggage box.

Disconnect the luggage box light switch connector and check for continuity between the switch terminals.

There should be no continuity with the luggage box light switch pushed, and there should be continuity with the luggage box light switch is released.

Lights/Meters/Switches

See also:

 Kymco XCITING 500 - Service Manual > Service Information

SERVICE INFORMATION GENERAL A halogen head light bulb becomes very hot while the head light is on, and remains for a while after it is turned off. Be sure to let it cool down before servicing. Note the following when replacing the halogen headlight bulb Wear clean gloves while replacing the bulb. Do not put finger prints on the headlight bulb, as they may create hot spots on the bulb and cause it to fail. If you touch the bulb with your bare hands, clean it with a cloth moistened with alcohol to prevent its early failure. Be sure to install the dust cover after replacing the bulb. Check the battery condition before performing any inspection that requires proper battery voltage. A continuity test can be made with the switches installed on the scooter. Route the wires and cables properly after servicing each component.

 Kymco XCITING 500 - Service Manual > Oil Pressure Switch

INSPECTION If the oil pressure warning indicator stays on while the engine running, check the engine oil level before inspection. Make sure that the oil pressure warning indicator come on with the ignition switch ON.