Kawasaki J300 - Service manual > Converter System
G: Apply grease.
R: Replacement Parts
Inside Circlip Pliers: 57001-143
Flywheel & Pulley Holder: 57001-1605
Oil Seal & Bearing Remover: 57001-1058
Clutch Drive Nut Fitting: 57001-Y022
Bearing Driver Set: 57001-1129
Clutch Spring Compressor: 57001-Y023
Intake Manifold Intake Manifold Removal Remove: Throttle Body Assy (see Throttle Body Assy Removal in the Fuel System (DFI) chapter) Fuel Injector (see Fuel Injector Removal in the Fuel System (DFI) chapter) Disconnect the water temperature sensor connector [A]. Clear the main harness from the clamp [B]. Remove: Intake Manifold Nuts [A] Intake Manifold [B] If necessary, remove the insulator [A].
Left Crankcase Cover Removal Remove: Left Lower Fairing (see Lower Fairing Removal in the Frame chapter) Left Crankcase Outer Cover Bolts [A] Left Crankcase Outer Cover [B] Remove: Left Crankcase Cover Bolts [A] Left Crankcase Cover [B] and Gasket