BMW C400GT - Rider's Manual > Fairings and panels

Remove battery cover

• Remove screws 1.

• Lift the battery cover 2 slightly at the edges.
• Pull the mounting clips 3 of the battery cover 2 out of the holders.

Installing battery cover

• Check whether all mounting clips 3 are mounted on the battery cover 2.
• Attach the battery cover 2 at the bottom and push the mounting clips 3 evenly into the mounts.

• Install screws 1.

Removing fairing side panel

• Remove the screws 1 for the fairing side panel.

NOTICE The operation described here for the left fairing side panel applies analogously to the right side.

• Lift the fairing side panel 2 slightly at the edges.
• Pull the mounting clips 3 of the fairing side panel 2 as evenly as possible out of the mounts.

Install fairing side panel

• Check whether all mounting clips 3 are installed on the fairing side panel 2.
• Position the fairing side panel 2 and push the mounting clips 3 evenly into the mounts.

NOTICE The operation described here for the left fairing side panel applies analogously to the right side.

• Install the screws 1 for the fairing side panel.

Data link connector

Removing the diagnostic connector

Requirement

The data link connector is located under the battery compartment cover by the leg shield.

• Remove battery cover

• Push in the locks 1.
• Release the data link connector 2 from the bracket 3.

  The diagnosis and information system interface can be connected to the data link connector 2.

Installing the data link connector

• Disconnect the diagnosis and information system interface.

• Plug the data link connector 2 into the bracket 3.

  The locks 1 engage.

• Installing battery cover.

See also: