Honda NSS300 Forza - Owner's Manual > Parts Location

• Document bag
• Luggage box
• Throttle grip
• Front brake fluid reservoir
• Fuse box 2, 3
• Front brake lever
• Right fairing pocket
• Battery
• Fuse box 1, Main fuse 1
• Main fuse 2
• Coolant reserve tank
• Engine oil drain bolt
• Engine oil fill cap/dipstick
• Tool kit

• Rear brake fluid reservoir
• Rear brake lever
• Left fairing pocket
• Seat
• Helmet holder
• Fuel fill cap
• Crankcase breather
• Spark plug
• Centre stand
• Oil filter
• Side stand

Instruments

• Speedometer
• Tachometer
• Coolant temperature gauge
  Displays the temperature of the engine coolant.

NOTICE Riding with the needle in the H (Hot) range may cause serious engine damage.

• Tachometer red zone
  (excessive engine rpm range)

NOTICE Do not operate the engine in the tachometer red zone.

Excessive engine speed can adversely affect engine life.

• RESET button
• MODE button
• Fuel gauge
  Needle in the red (E) mark, remaining fuel approximately 3.6 litres
  (0.95 US gal, 0.79 Imp gal)

• Average fuel consumption meter
• Odometer [TOTAL] & Tripmeter [TRIP A/B]
  MODE button switches between odometer & tripmeters.
  • Odometer: Total distance ridden.
  • Tripmeter: Distance ridden since tripmeter was reset (press and hold RESET button to reset to 0.0 km).
  • When you reset the tripmeter, the average fuel consumption meter is reset at the same time.

• Clock

Display Check

When the ignition switch is turned ON, all the meter and gauge needles swing to the maximum scale on the dial once, all the mode and digital segments will show. If any part of these displays does not come on when it should, have your dealer check for problems.

Instruments (Continued)

Average fuel consumption meter

Except E, U, KO type

Shows average fuel consumption in km/â„“ or â„“/100km based on the tripmeter A.

Select the km/â„“ or â„“/100km, press and hold the MODE button with the tripmeter.

After you reset the tripmeter A, the average fuel consumption meter shows "".

E type only

Shows average fuel consumption in mile/gal, km/â„“ or â„“/100km based on the tripmeter A.

Select the mile/gal, km/â„“ or â„“/100km, press and hold the MODE button with the tripmeter.

After you reset the tripmeter A, the average fuel consumption meter shows "".

Instruments (Continued)

U type only

Shows average fuel consumption in â„“/100km based on the tripmeter A.

After you reset the tripmeter A, the average fuel consumption meter shows "".

KO type only

Shows average fuel consumption in km/â„“ based on the tripmeter A.

After you reset the tripmeter A, the average fuel consumption meter shows "".

To set the clock:

1. Turn the ignition switch ON.
2. Press and hold MODE and RESET buttons until the hour digits start flashing.

3. Press RESET button until the desired hour is displayed.
   • Press and hold to advance the hour fast.

4. Press MODE button. The minute digits start flashing.

5. Press RESET button until the desired minute is displayed.
   • Press and hold to advance the minute fast.

6. Press MODE button. The clock is set.
   • The time can also be set by turning the ignition switch OFF.

     The display will stop flashing automatically and the adjustment will be cancelled if the button is not pressed for about 2 minutes.

See also: