Peugeot Satelis - Service manual > Removal of the rear shield panel

• Remove the ignition key.
• Remove the tank cover panel. See: Procedure 5.
• Remove the front top cover panel. See: Procedure 7.
• Remove:
  • The ignition switch trim.
  • The handlebar upper fairing (8 screw) (1).

• On each side remove:
  • 2 plastic screws that secure the front leg shield to the underbody cover.
  • 2 plastic screws that secure the footboard to the underbody cover.
• Push aside the underbody cover to reach the screw that secures the front shield panel. (2)

• On each side remove:
  • 6 plastic screws. (3)
  • 2 washer head screws. Ø6 mm. (4)

• Separate the front shield panel from the rear shield panel in order to reach the bracket that connects the rear shield panel to the footboard. (A)
• Pull upwards the lower part of the shield panel in order to separate it from the footboard.

• Relove the eyelet (B) from the shield panel and the eyelet (C) from the instrument cluster fairing in order free the rear shield panel.

• Topple the rear shield panel while separating it from the footboards in order to reach the header tank and the accessory plug.
• Remove the header tank. (Right side).
• Disconnect the accessory plug. (Left side).
• Remove the rear shield panel.

Removal of the instrument cluster

• Remove:
• The front top cover panel. See: Procedure 7.
  • The wind deflector.
  • The handlebar upper fairing.
• On each side remove:
  • 1 plastic screw. (1)
  • 1 washer head screw. Ø5 mm. (2)
  • 1 washer head screw. Ø6 mm. (3)

• Press the locking system (1) to actuate the positioning lever (2) of the instrument cluster's connector.
• Push the lever all the up (A) in order to remove the connector from the instrument cluster.
• Remove the instrument cluster fairing.

Note: When connecting, the lever must be pushed all the way to (A) in order not to damage the connector.

Removal of the dirt shield

• Remove the front shield panel. See: Procedure 8.
• Remove the center screw which secures the dirt shield to the underbody cover.
• Disconnect the speed sensor.
• Pull the speed sensor control out of the dirt cover.
• Lift the front of the vehicle while making sure the wheel is in line with the vehicle.
• Remove the dirt cover by sliding it behind the wheel as shown.

When removing the dirt cover make sure it doesn't rub against the radiator.

Removal of the battery holder

Procedure 9.

• Remove the tank cover panel. See: Procedure 5.
• Disconnect and remove the battery.
• Unclip from the battery holder:
  • The fuses. (1)
  • The relays. (2)
  • The diagnosis plug.(3)
• Remove the battery bracket. (2 screws and 1 nuts).

See also: